How to install Android 4.2.2 Jelly Bean XXUFME7 leaked firmware for Samsung Galaxy S3 I9300 !!!

Earlier I have informed you about Android 4.2.2 Jelly Bean firmware leaked for Samsung Galaxy S3 I9300 !!!
Now I am going to show you the procedure How you can install Android 4.2.2 Jelly Bean XXUFME7 leaked firmware for Samsung Galaxy S3 I9300

To install Android 4.2.2 Jelly Bean firmware for Samsung Galaxy S3 I9300, you have to go through the following process :

• Download the XXUFME2 I9300 firmware zip file from HERE.
  > save the file on your PC and then extract its contents.
  > you will get a file with the .tar.md5 extension and you shouldn’t extract any further than that.
• Download Odin3 v3.07 from here.
• Extract its contents and place them all in a single folder.
• Power off your smartphone completely.
• Boot the Galaxy S3 into Download Mode 

# Power off the phone completely by removing its battery for 5 seconds.

# Re-insert the battery back into its place.

# Press and hold Volume Down, Home and Power buttons, all at the same time.

# Release the buttons only when the ‘Warning!!’ message appears.

# Next, press Volume Up button to confirm that you wish to enter Download Mode.

# Your device will now show a green Android with the ‘Downloading… Do not turn off target’ text listed under it.

# That’s it, now you can connect your device with your PC after you launch ODIN.

• Launch Odin exexutable on your computer.
• Connect the phone with your PC using the USB Cable.
  > Odin will say that the device has been ‘added!!’ and then you can continue to the next step.
  > if Odin doesn’t recognize the device, then you should try to plug it in a different USB port or re-install the Samsung USB Drivers.
• Now, click the ‘PDA’ button in Odin and browse your PC for the file extracted in step 1, the tar.md5 file. Load it into Odin.
  > make sure that Re-Partition option is not enabled.
  > don’t edit any other default Odin settings.
• Click ‘START’ to begin the installation of XXUFME2 Android 4.2.2 Jelly Bean. This process shouldn’t take longer than 5 minutes.
• When the install is complete, you will see that the phone has rebooted and Odin should display the ‘PASS’ message, which confirms that the new firmware has been flashed with success.
• When the Samsung boot animation appears, you can unplug the phone from PC and wait for the home screen to appear.
• Enter your Google Account info and take control over your device.

Yes ! Its done ! Now you have installedAndroid 4.2.2 Jelly Bean on your Samsung Galaxy S3 I9300 !

*** To get more updated info, join with us on Facebook